Filter
Top Products
Administration Settings
Logging
Cisco SPA232D Administration Guide 190
5
Log Setting
If logging is enabled on the Administration > Log > Log Module page, the ATA can
periodically send the log file to a server or to an email address. Use the Log
Setting page to enter the information for your syslog server and email account.
NOTE For information about enabling and configuring logging, see Log Module,
page 188.
To open this page: Click Administration in the menu bar, and then click Log > Log
Setting in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to redisplay the page with the saved settings.
Local
Syslog Server
NOTE TLS 1.2 is supported on the ATA. The new openssl library is compatible with the old
version (supports TLS1.0 and older.) The actual protocol version used in a session
is negotiated between the server and the client in the handshake phase.
Syslog Server Check the box in the heading row to include all services
in the log file that is transmitted to the syslog server.
Alternatively, check the box for kernel or system to
include that service in the log file.
Field Description
Field Description
Log Size Enter the maximum size of the log file in kilobytes. Valid
values are from 128 to 1024.
Field Description
IP Address Enter the IP address of the syslog server where the
messages will be sent.
Port Enter the port to use on the server. Valid values are from
1 to 65535.