Filter
Top Products
A
Cisco SPA232D Administration Guide 204
Frequently Asked Questions
Q. I cannot connect to the Internet through the ATA.
STEP 1 Make sure that the ATA is powered on. The Power/Sys LED should be solid green
and not flashing.
If the Power LED is flashing, then power off all of your network devices, including
the modem, the ATA, and the connected devices. Wait for 30 seconds. Then
power on each device in the following order:
• Cable or DSL modem
• ATA
• Connected Devices
STEP 2 Check the cable connections. Ensure that the cable in the INTERNET (WAN) port is
securely connected to the device that provides your Internet access, such as your
modem or ADSL line. On the Cisco SPA122, check the cable connection for the
ETHERNET (LAN) port.
STEP 3 Check the settings on the Network Setup > Internet Settings page. Verify that you
entered the settings specified by your Internet Service provider.
Q. I upgraded my firmware and now the ATA is not working properly.
If the ATA is not working properly after an upgrade, you may need to perform a
factory reset. Use the Administration > Factory Defaults page to reset the ATA to
the default configuration. Alternatively, press and hold the RESET button for 20
seconds. All user-changeable non-default settings will be lost. This may include
network and service provider data.
Q. I cannot use the DSL service to connect manually to the Internet.
After you have installed the ATA, it will automatically connect to your service
provider’s network, so you no longer need to connect manually.