Filter
Top Products
5-11
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 5 Configuring the Cisco IP Phone Models 7905G and 7912G Using the Phone Menus
Network Configuration Menu
CDP Enabled Indicates whether Cisco Discovery
Protocol (CDP) is enabled for the
phone. CDP allows the phone to be
discovered by the CiscoWorks
network management system.
For more information about
CiscoWorks2000, refer to the
documentation available at this
URL:
http://www.cisco.com/univercd/cc
/td/doc/product/rtrmgmt/cw2000/i
ndex.htm
1. Unlock configuration parameters.
2. Scroll to the CDP Enabled parameter and
press the No softkey to disable CDP, or
press the Ye s softkey to enable CDP.
3. Press the Save softkey.
DHCP Enabled Specifies whether to use the DHCP
server to obtain information such
as its IP address, its subnet mask,
and the IP addresses of the network
gateway and the DNS, NTP, and
TFTP servers.
If this parameter is 0, you must
manually specify the IP address of
the phone, and the subnet mask and
the network gateway (default
router) used by the phone. See the
“Minimum Configuration Settings
for the Cisco IP Phone Models
7905G and 7912G” section on
page 3-9 for more information.
1. Unlock configuration parameters.
2. Scroll to the DHCP Enabled parameter
and press the No softkey to disable
DHCP, or press the Yes softkey to enable
DHCP.
3. Press the Save softkey.
Table 5-1 Network Configuration Menu Parameters (continued)
Parameter Description To Change