Filter
Top Products
A-3
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Appendix A Additional End User Features on the Cisco IP Phone Models 7905G and 7912G
Call Preferences Menu
Do Not Disturb Specifies whether calls to the phone will
receive a busy signal.
When this parameter is set to Yes, the DND
softkey becomes available on the phone.
See the “Softkeys” section on page A-6 for
more information.
1. Scroll to the Do Not Disturb
parameter and press the Yes
softkey to enable this parameter, or
press the No softkey to disable it.
2. Press the Save softkey.
Allow Call
Waiting
Specifies whether call waiting is enabled on
the phone.
1. Scroll to the Allow Call Waiting
parameter and press the Yes
softkey to enable this parameter, or
press the No softkey to disable it.
2. Press the Save softkey.
Block Caller
ID
Specifies whether caller ID is blocked on
outgoing calls. If this parameter is set to
Yes, outgoing calls will use “Anonymous”
as the phone’s caller ID. If it is set to No, the
phone’s caller ID will include the Display
Name value and phone number.
1. Scroll to the Block Caller ID
parameter and press the Yes
softkey to enable this parameter, or
press the No softkey to disable it.
2. Press the Save softkey.
Block
Anonymous
Call
Specifies whether anonymous calls are
rejected. If this parameter is set to Yes,
incoming calls with “Anonymous” caller
IDs will be rejected. If it is set to No, these
calls will ring at the phone.
1. Scroll to the Block Anonymous
Call parameter and press the Yes
softkey to enable this parameter, or
press the No softkey to disable it.
2. Press the Save softkey.
Allow Call
Transfer
Specifies whether attended call transfers
can be made from the phone. If this
parameter is set to Yes, the Trnsfer softkey
will appear when appropriate, allowing
attended transfers of a calls. If this
parameter is set to No, this softkey will
never be available.
1. Scroll to the Allow Call Transfer
parameter and press the Yes
softkey to enable this parameter, or
press the No softkey to disable it.
2. Press the Save softkey
Table A-1 Call Preference Menu Parameters (continued)
Parameter Description To Change