Filter
Top Products
8-23
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 8 Profile and Web Page Parameters and Defaults
Tone Parameters
RingOnOffTime Specifies the ringer cadence pattern, expressed as three comma-separated
integers a,b,c, where:
• a—Number of seconds to wait before turning the ring on.
• b—Number of seconds to wait before turning the ring off.
• c—Ring frequency.
Value type: Three comma-separated integers.
Default value: 2,4,25
DialTone Tone that plays when the phone is ready to accept the first digit of a telephone
number or an IP address.
See the “BusyTone, CallWaitTone, DialTone, DialTone2, and RingBackTone
Parameter Details” section on page 8-28 for syntax and usage details.
Value type: Array of 11 short integers.
Default value: 2,31538,814,30831,2032,0,0,0,0,0,0
DialTone2 Secondary dial tone. For example, this tone might play after you dial a number
to obtain an outside line.
See the “BusyTone, CallWaitTone, DialTone, DialTone2, and RingBackTone
Parameter Details” section on page 8-28 for syntax and usage details.
Value type: Array of 11 short integers.
Default value: 2,30743,1384,29864,1252,0,0,0,0,0,0
BusyTone Tone that plays when the called party’s line is busy.
See the “BusyTone, CallWaitTone, DialTone, DialTone2, and RingBackTone
Parameter Details” section on page 8-28 for syntax and usage details.
Value type: Array of 11 short integers.
Default value: 2,30467,1104,28959,1404,1,4000,4000,0,0,0
Table 8-4 Tone Parameters (continued)
Parameter Description