Filter
Top Products
Chapter 8 Profile and Web Page Parameters and Defaults
Parameter Details
8-38
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
DialPlan Parameter Detail
The DialPlan parameter specifies dial plan rules.
Note No syntax check is performed by the implementation of this parameter. It is the
responsibility of the provisioner to make sure that the dial plan is syntactically
valid.
24 Include RTP statistics in BYE request and response.
• 0=Disable (default).
• 1=Enable.
If this bit is enabled, the phone will insert the headers RxStat and TxStat as follows:
RxStat: Dur=a,Pkt=b,Oct=c,LatePkt=d,LostPkt=e,AvgJit=f
TxStat: Dur=g,Pkt=h,Oct=i
where:
• Dur is the total number of seconds since the beginning of reception or transmission
• Pkt is the total number of RTP packets received or transmitted
• Oct is the total number of RTP payload octets received or transmitted (not including
RTP header)
• LatePkt is the total number of late RTP packets received
• LostPkt is the total number of lost RTP packets received (not including late RTP
packets)
• AvgJit is the average jitter, which is an estimate of the statistical variance of the RTP
packet inter-arrival time, measured in timestamp unit and calculated according to
RFC 1889.
• a, b, c, d, e, f, g, h, and i are integers
25–31 Reserved. Must be set to 0.
Table 8-9 ConnectMode Parameter (continued)
Bit Description