Filter
Top Products
8-3
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 8 Profile and Web Page Parameters and Defaults
Network Parameters
Table 8-1 Network Parameters
Parameter Description
UseTftp Enables or disables downloading of a profile from a TFTP server. If you set this
parameter to 1 and subsequently make changes using the web interface, you
must set this parameter to 0 before saving those changes; otherwise, the
changes will be overwritten by the profile obtained from a TFTP server.
• 0=Do not use a TFTP server.
• 1=Use a TFTP server:
–
If TftpURL is set to 0, use the TFTP IP address or URL obtained from
the DHCP server to contact the TFTP server.
–
If TftpURL is set to a value other than 0, use the specified IP address
or URL to contact the TFTP server.
Note Do not specify a port. The Cisco IP Phone always contacts the TFTP
server at port 69.
Value type: Boolean.
Default value: 1
TftpURL IP address or URL of the TFTP server from which a phone obtains a profile.
Required if the DHCP server does not provide the TFTP server address.
Optionally, you can include the path prefix to the profile to download. For
example, if the TFTP server IP address is 192.168.2.170 or www.cisco.com,
and the path to the file is /ip7905, you can specify the URL as
192.168.2.170/ip7905 or www.cisco.com/ip7905.
Do not specify a port. The Cisco IP Phone always contacts the TFTP server at
port 69.
If DHCP is used, a nonzero values of TftpURL overwrites any DHCP-supplied
addresses and values of 0 tell the phone to use DHCP-supplied addresses.
This parameter is ignored if UseTftp is 0.
Value type: IP address, up to 31 characters.
Default value: 0.0.0.0