Filter
Top Products
Chapter 4 Basic and Additional SIP Services
Additional SIP Services
4-4
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Establishing Authentication
The UseLoginID parameter lets you select the user ID for authentication of the
phone to the remote end as follows:
• If UseLoginID is set to 0, the user ID (set with the UID parameter) is used
with a user-supplied password (set with the PWD parameter) for
authentication.
• If UseLoginID is set to 1, you must supply a login ID (set with the LoginID
parameter) and a password (set with the PWD parameter) for authentication.
Configuring Refresh Interval
When the value specified with the CfgInterval parameter is reached, the
Cisco IP Phone attempts to refresh its configuration file from the TFTP server.
(You can manually perform a refresh before the scheduled refresh as explained in
the “Refreshing the Cisco IP Phone” section on page 6-17.)
When a Cisco IP Phone contacts the TFTP server, it also checks to see if a
firmware image has been placed on the TFTP server. If such an image exists, the
phone will download this image.
Additional SIP Services
Table 4-2 describes additional SIP services and provides references to additional
information. These services are listed alphabetically.
Note Many of the descriptions in Table 4-2 refer to specific parameters that you can set
in a profile or from a phone’s web page. For the corresponding parameter in the
phone configuration menus, see Appendix B, “Phone Menu, Web Page, and
Profile Equivalent Parameters.”