Filter
Top Products
8-7
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 8 Profile and Web Page Parameters and Defaults
Network Parameters
OpFlags Enables or disables various operational features.
• Bit 0: If 0, the TFTP phone-specific profile file name supplied by the
DHCP server overwrites the default file name for each phone. If 1, the
phone uses the default profile file phone-specific name (recommended).
• Bit 1: If 0, enables probing of the static network router when the phone
powers up. If 1, probing is disabled (recommended).
• Bit 2: Reserved.
• Bit 3: If 0, request DHCP option 150 in the DHCP discovery message. If
1, do not request this option. (Some DHCP servers do not respond if option
150 is requested.)
• Bit 4: If 0, do not use VLAN ID set with the VLANSetting parameter. If
1, use VLAN ID (recommended).
• Bit 5: If 0, use VLAN IP encapsulation. If 1, do not use VLAN IP
encapsulation.
• Bit 6: If 0, perform CDP discovery. If 1, do not perform CDP discovery.
• Bit 7: If 0, allow configuration of the phone through the web. If 1, do not
allow configuration through the web.
• Bit 8: If 0, allow refreshing the phone through the web. If 1, do not allow
refreshing the phone through the web.
• Bit 9: If 0, allow resetting the phone through the web. If 1, do not allow
resetting the phone through the web.
• Bits 10-31: Reserved.
Value type: Bitmap.
Default value: 0x00000002
Table 8-1 Network Parameters (continued)
Parameter Description