Filter
Top Products
Chapter 8 Profile and Web Page Parameters and Defaults
Network Parameters
8-4
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
CfgInterval Number of seconds between automatic profile refreshes from the TFTP server.
At the earliest idle time following each interval expiration, the phone retrieves
its profile using the tftp get command. Intervals should vary among phones on
the network to prevent simultaneous contact of the TFTP server by many
phones.This value can range from 60 to 4294967295.
This parameter is ignored if UseTftp is 0.
Value type: Integer.
Default value: 3600
EncryptKey Key for decrypting the configuration profile that is downloaded from the TFTP
server.
• 0=The configuration profile is not encrypted.
• string=The profile is encrypted with this key.
This parameter is ignored if UseTftp is 0.
Value type: Alphanumeric string, up to 8 characters.
Default value: 0
Dhcp Specifies whether to use the DHCP server to obtain information such as IP
addresses for the phone, the network gateway, and the DNS, NTP, and TFTP
servers.
If this parameter is 0, you must manually specify the IP address of the phone,
and the IP addresses of the subnet mask and the default router used by the
phone. See the “Minimum Configuration Settings for the
Cisco IP Phone Models 7905G and 7912G” section on page 3-9 for more
information.
• 0=Do not use the DHCP server. Use hard-coded values.
• 1=Use the DHCP server.
Value type: Boolean.
Default value: 1
Table 8-1 Network Parameters (continued)
Parameter Description