Filter
Top Products
6-17
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Chapter 6 Configuring the Cisco IP Phone Models 7905G and 7912G Using a TFTP Server
Refreshing or Resetting the Cisco IP Phone
Refreshing or Resetting the Cisco IP Phone
When you make configuration changes to a Cisco IP Phone profile, you can
refresh or reset the Cisco IP Phone for these configuration changes to
immediately take effect. If you do not refresh or reset the phone, the configuration
changes will take effect the next time the phone contacts the TFTP server, which
occurs based on the configured value of the CfgInterval parameter.
A refresh procedure will update a phone with the current profile. A reset
procedure will update a phone with the current profile and will power-down and
power-up the phone. A reset is not necessary if your only goal is to update a
phone’s profile.
Note You use bits 8 and 0 of the OpFlags parameter prevent end users from refreshing
or resetting a phone. See the “Network Parameters” section on page 8-2 for more
information.
This section includes the following topics:
• Refreshing the Cisco IP Phone, page 6-17
• Resetting the Cisco IP Phone, page 6-17
Refreshing the Cisco IP Phone
To refresh the Cisco IP Phone, enter the following command from your web
browser:
http://<ipaddress>/refresh
where ipaddress is the IP address of the Cisco IP Phone that you are refreshing.
Resetting the Cisco IP Phone
To reset the Cisco IP Phone, enter the following command from your web
browser:
http://<ipaddress>/reset
where ipaddress is the IP address of the Cisco IP Phone that you are resetting.