Filter
Top Products
Chapter 8 Profile and Web Page Parameters and Defaults
Profile Parameters
8-26
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
OL-4277-01
Profile Parameters
Table 8-6 describes the parameters that you can configure through a phone’s
profile only.
For more information about profiles, see Chapter 6, “Configuring the Cisco IP
Phone Models 7905G and 7912G Using a TFTP Server.”
ConnectMode Connection mode for the selected call-signaling protocol.
See the “ConnectMode Detail” section on page 8-36 for syntax and usage
details.
Value type: Bitmap.
Default value: 0x00000000
NumTxFrames Number of frames per outbound audio RTP packet. For G.711 and G.729
codecs, a frame is 10 ms. Cisco recommends that you use the default value.
Valid values are 1, 2, 3, 4, 5, or 6.
Value type: Integer.
Default value: 2
Table 8-5 Audio Parameters (continued)
Parameter Description
Table 8-6 Profile Parameters
Parameter Description
UIPassword Password to access the phone’s configuration web page, and to unlock the
phone’s Network Configuration and SIP Configuration menus for editing.
If set to 0, configuration parameters cannot be modified from a phone’s web
page. In addition, if set to 0, the phone will not prompt for a password when
you unlock configuration parameters on the phone.
Value type: Alphanumeric string up to nine characters.
upgradecode Provides information for upgrading the firmware image on the phone.
See the “Upgradecode Parameter Detail” section on page 8-41 for syntax and
usage details.