Filter
Top Products
Configuring Network Use
3 - 29
To make the enabled call types available on the Place a Call screen, you must
enable the Call Quality setting described on page 4-48.
1. Select and configure these settings:
Enable ISDN
H.320
VSX 3000
VSX 3000A
VSX 7000
VSX 7000s
VSX 7000e
VSX 8000
Allows the system to make ISDN calls.
This selection is only available when the system has ISDN
networking capability.
Enable Voice
Over ISDN
Allows the system to make voice-only calls to phones
connected to an ISDN network, such as an organization’s
PBX.
Enable
V.35/RS-449/
RS-530
VSX 7000
VSX 7000s
VSX 7000e
VSX 8000
Allows the system to make calls through your third-party
network equipment.
This selection is only available when the system has a
V.35/RS-449/RS-530 network module installed.
Enable Analog
Phone
VSX 7000e
VSX 8000
Allows the system to make voice-only calls to any phone using
an analog phone line.
Disable this setting to remove a SoundStation VTX 1000
conference phone from the dialing order.
Enable ISDN
Gateway
Allows users to choose whether to place IP-to-ISDN calls
through a gateway.
Setting Description
Setting Description
Preferred Dialing
Method
Specifies the preferred method for dialing various call types. If
set to Auto, calls use the configured Dialing Order. If set to
Manual, the system prompts the user to select the call type
from a list when placing a call.
Dialing Order Specifies how the system places calls to directory entries that
have both IP and ISDN numbers. It also specifies how the
system places calls dialed manually, when the call type
selection is either unavailable on the home screen or set to
Auto. If a call attempt does not connect, the system tries to
place the call using the next call type in the Dialing Order.
This setting is available only when Preferred Dialing Method
is set to Auto.
For more information, refer to Configuring Dialing Order
Settings on page 3-30.