Filter
Top Products
Handset Using the MDW 9031/9031DCP Pocket Phone 3
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 85
The higher the number, the better the voice quality, as shown in the table below. A
low number may indicate potential interfering devices (such as another radio
transmitter) in the area. You can press 2 again to show a subsequent voice-
quality reading. Each time you press 2, you get a new reading.
9 To determine power level, press 5.
The display shows the power level to which the handset (HS) and the base (B)
(the radio module) have adjusted. The power level adjusts from low power (1) to
high power (8) as the Pocket Phone is moved farther from its base. The following
display shows the Pocket Phone at its highest setting:
10 To exit Wireless Test Mode and Local Mode, press O.
Performance /Range
Test in Wireless Test
Mode
Using the signal-strength test and the voice-quality test together, you can determine:
• if the installation has been done correctly.
• if the handsets and bases are working properly.
• the range in which your MDW 9031/9031DCP Pocket Phone performs best at
your site.
Display Number Voice Quality Is
10 Very Good
9 Very Good/almost error free
8 Errors, but not noticeable in normal
speech
7 Errors, but not noticeable in normal
speech
6 Noticeable noise
5 Noticeable noise
4 Noisy but intelligble speech
3 Noisy but intelligible speech
2 Garbled speech
1 Unintelligible speech
ON