Filter
Top Products
2 Installing the MDW 9031/9031DCP Pocket Phone Battery Charger
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16668 Issue 3 October 1999
Inserting the Handset into the Battery Charger’s Handset Cradle
Correct positioning of the handset in the charger is important to ensure proper charging:
1 Position the handset (with either battery pack attached) so that the two small
round holes in the bottom of the handset fit over the two guide pins on the bottom
of the handset cradle.
2 Rock the handset back into the cradle until it is firmly seated with the back of the
handset battery pack against the back of the handset cradle.
When the handset has been inserted correctly, the following occur:
• The HANDSET LED lights.
• If the handset was turned on, the ON icon in the display is no longer visible.
• Any call that was in progress is terminated.
• After 15 seconds, the handset enters the energy-saving “sleep” mode.
Removing the Handset from the Handset Cradle
To remove the handset from the handset cradle, lift it out.
SPARE
HANDSET
REFRESH
O
PER
0
On/Off
F
e
a
t/P
C
o
n
f
GHI
PQRS
T
ra
n
s
H
o
ld
R
e
d
ia
l
1
2
4
JKL
ABC
3
DEF
5
MNO
6
TUV
8
W
XYZ
9
7
M
u
te
SPARE
HANDSET
REFRESH
On/Off
Feat/P
Conf
GHI
P
Q
R
S
O
P
E
R
Trans
Hold
Redial
12
4
JKL
ABC
3
DEF
5
MNO
6
TUV
8
0
W
X
Y
Z
9
7
Mute
HANDSET LED
Guide Pins