Filter
Top Products
3 Using the MDW 9031/9031DCP Pocket Phone Handset
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16682 Issue 3 October 1999
Test Modes
You can use Local Test Mode and Wireless Test Mode to verify that your handset is working properly and that
the MDW 9031/9031DCP System is performing optimally.
Using Local Test Mode
You can use Local Test Mode to activate the audio warning signal, the vibrator, and all visual indicators on the
handset display, enabling you to test the following:
• Does the audio warning signal work?
• Does the vibrator vibrate?
• Is the display operational?
• Are the visuals bright and clear?
Note: While in Local Test Mode, the MDW 9031/9031DCP cannot make or
receive calls.
To use Local Test Mode:
1 Make sure the handset is turned off.
2 Press and hold the Select button ( " ) for three seconds.
3 While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating
you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still
receive notification of incoming calls.)
4 Press # to enter Local Test Mode.
The handset emits two beeps, the vibrator vibrates, and all indicators on the
display appear (including the rectangles and truncated triangles), as shown below.
If the beeps do not sound, the vibrator does not vibrate, or the indicators do not
appear, repeat Steps 1–4. If you still have problems, call for customer support as
described on the inside front cover of this book.
5 To exit both Local Test Mode and Local Mode, press O once.
Note: You must exit Local Test Mode to reinstate proper call handling.
Local Test Mode
MSG
ON
RANGE MUTE