Lucent Technologies MDW 9031 Cordless Telephone User Manual


 
Procedures Troubleshooting 5
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 117
Battery Charger Problems
Symptoms Possible Causes Possible Solutions
No LEDs on battery
charger light.
Battery charger is plugged into an
electrical outlet controlled by a switch
and the switch is turned off.
Plug the battery charger into an
outlet not controlled by a switch.
HANDSET LED on
battery charger does not
light when handset is
placed in battery
charger.
Handset is not seated properly in
battery charger’s handset cradle.
Contacts in the handset cradle or on
the battery pack are dirty.
Battery pack is defective.
Reseat the handset in the battery
charger's handset cradle, as
described in Chapter 3.
1 Verify that there are no
obstructions on the handset or
battery charger contacts.
2 Unplug the charger and clean
the contacts with a soft eraser.
3 Clean the handset contacts with
a soft eraser.
If you have a fully charged spare
battery pack, use it to replace the
battery pack in the handset.
1 Place the questionable battery
pack in the battery charger’s
spare battery compartment.
2 Wait one minute. If the SPARE
LED flashes red, order a new
battery pack.