Filter
Top Products
Installing Multiple Carriers Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 41
3 If you are using a Model 117A4 carrier, verify that the carrier’s
CONTROL/EXPANSION LED is lit and that its color is green. This is correct
for a single-carrier installation.
4 Verify that the POWER and PASS LEDs on each radio module are lit. If a radio
module’s PASS LED does not light, power down the carrier and the module, wait
15 seconds, and repower the module and then the carrier. If the PASS LED still
does not light, refer to Chapter 5, “Troubleshooting.”
Note: The RADIO LED also may light upon installation; however, since the
RADIO LED has no significance during installation, ignore its operation.
The RADIO LED indicates a connection between the handset and the
radio module; it lights when the handset is being used as long as the
battery pack in the handset is charged.
Installing Multiple Carriers
• Install each carrier high on a wall, leaving 6 to 12 inches (15.2 to 30.5 cm)
between the top of the antennas and the ceiling.
• Install each carrier 1 foot (0.3 m) optimally to 4 feet (1.2 m) from its neighboring
carrier.
• Never install or remove a radio module from a carrier that is plugged into a wall
outlet (hot insertion).
• See “Key Components” earlier in this chapter for additional picture detail.
P
O
W
E
R
R
A
D
IO
PASS
Radio
Module
POWER
RADIO
PASS
Go to “Handset.”