Filter
Top Products
Handset Using the MDW 9031/9031DCP Pocket Phone 3
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 73
When the display is blank, the handset is either turned off or in the power-saving “sleep” mode. You can activate
the display and Backlighting (if programmed) by pressing O, turning the handset on, or by pressing " to
“wake it up.”
Display Messages The top line of the handset display uses up to 16 alphanumeric characters to provide
messages such as the following:
• LCL:P (or LCL:D, LCL:M1, or LCL:M2) indicates that the handset is in Local
Mode, and tells which communications system the button mapping is set to
emulate:
• WIRELESS TEST indicates that the handset is in Wireless Test Mode; 1 through
10 are used to measure signal strength and voice quality in Wireless Test Mode.
• VIBR indicates that the vibrator is enabled to notify you of incoming calls.
• PSEL indicates that Line Preselection is enabled.
• PRESELECTION:ON or PRESELECTION:OFF is displayed when you enter
Preselection Mode, and indicates the status of the Line Preselection option.
• CHANGE BUTTN MAP is an error message indicating that the handset is set
for the wrong communications system. See “Changing the Communications
System Setting” in Chapter 2 for instructions for changing the setting.
• MAP:P (or MAP:D, MAP:M1, or MAP:M2) is displayed when you enter
Button Mapping Mode, and indicates the communications system to which the
MDW 9031/9031DCP buttons are currently mapped:
• RANGE is an error message indicating that the handset is not communicating
with its radio module. See Chapter 5, “Troubleshooting,” for help in resolving
this problem.
LCL:P PARTNER Systems
LCL:D DEFINITY Systems, System 25, System 75, and
System 85
LCL:M1 All MERLIN Systems (except MERLIN 410
and MERLIN 820), including MERLIN LEGEND
LCL:M2 MERLIN 410 and MERLIN 820
MAP:P PARTNER Systems
MAP:D DEFINITY Systems, System 25, System 75, and
System 85
Note: The MDW 9031DCP should only be set
to MAP:D for DEFINITY.
MAP:M1 All MERLIN Systems (except MERLIN 410
and MERLIN 820), including MERLIN LEGEND
MAP:M2 MERLIN 410 and MERLIN 820