Filter
Top Products
Installing Multiple Carriers Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 53
5 The PASS and POWER LEDs on all radio modules should be lit and green. If a
radio module’s PASS LED is not lit:
a Power down the carriers.
b From the wall outlet, unplug the power cord/AC adapter of the radio module
that did not light.
c Wait 15 seconds.
d Plug in the radio module’s power cord again.
e Repower the carriers, following the proper left-to-right order.
If the PASS LED is still not lit, follow the suggestions in the “Installation
Problems” section of Chapter 5, “Troubleshooting.” If the LED is still not lit,
call Customer Support as described in the Copyright and Legal Notices at the
beginning of this book.
6 Verify that LEDs match the pattern in the illustration in Step 2; if so, you can feel
confident that the carriers are cabled correctly and that the installed radio modules
are all functional.
7 Go to “Installing the Remaining Radio Modules” (page 54).
P
O
W
ER
R
AD
IO
PASS
Radio
Module
POWER
RADIO
PASS