Filter
Top Products
✃
✃
✃
Battery Charger Wall-Mounting Template
Use the template below to position the screws for mounting your MDW 9031/9031DCP Pocket
Phone battery charger:
1 Cut out the template along the dotted line.
2 Lightly affix the template to the wall with tape where you want to
attach the battery charger. If possible, choose a location that will
position at least one of the screw holes over a wall stud.
3 Mark the wall.
4 Position a wall spacer on each of the two wood screws provided,
and insert the screws in the wall as far as they will go at the places
you marked.
Note: If you cannot locate a wall stud for one of the screws, use
molly bolts or another type of hollow-wall fastener. Be
sure to place the wall spacers on the screws before
inserting them permanently.
1.5 inches (3.81 cm)
center to center