Filter
Top Products
Handset Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 61
3 To remove the battery pack, slide the spring latch upward (away from the battery
pack). While holding the latch up, grasp both sides of the battery pack, then
gently pull the battery pack upward and out.
Changing the Communications System Setting
The communications system you use determines what information the MDW 9031/9031DCP Pocket Phone can
display and how the phone lines and programmable/intercom/drop buttons are identified. (For the MDW 9031,
see the appropriate “Button Mapping” topics in the “MDW 9031 Compatibility” section in Chapter 6. For the
MDW 9031DCP, see the “Button Mapping” topic in the “MDW 9031DCP Compatibility” section in Chapter 6.)
The MDW 9031 is factory-set to work with the PARTNER communications system. If you are using
PARTNER as your communications system, skip this section; if you are using a different communications
system, you will need to change the setting.
The MDW 9031DCP is factory-set to work with the DEFINITY communications system.
To change the communications system setting, use the following procedure to enter Local Mode and then Button
Mapping Mode:
1 Make sure the handset is turned off.
2 Press and hold the Select button ( " ) for three seconds.
3 While still holding ", press O.
The handset beeps twice, and the top line of the display shows LCL:P (unless you
have already changed it from the default setting).