Filter
Top Products
Installing a Single Radio Module Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 17
Additional Rules for
Installing One or More
Carriers
• Install carrier(s) within 15 feet (5 m) of either side of, and within 6 to 8 feet (1.8
to 2.4 m) above, a properly grounded, 3-prong electrical outlet that is not
controlled by an on/off switch.
• Choose a location where handset users will not approach the carrier(s)
within a radius of 6 feet (1.8 m) for 1 or 2 carriers or 10 feet (3 m) for 3
carriers.
• When installing multiple carriers:
~ Install multiple carriers 1 foot (0.3 m) optimally to 4 feet (1.2 m) apart.
~ Install multiple carriers on the same horizontal axis (do not install one carrier
higher or lower than another).
~ Install the control carrier as the leftmost carrier, using only the expansion
cables provided.
~ Slot 6 of an 117A3 control carrier must always contain a radio module to pass
the synchronization signal to the next carrier.
!
CAUTION:
Carrier(s) cannot be installed outdoors.
Installing a Single Radio Module
• Install a single radio module high on a wall, leaving 6 to 12 inches (15.2 to
30.5 cm) between the top of the antenna and the ceiling.
• See “Key Components” earlier in this chapter for additional picture detail.
To install a single radio module:
1 Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to
determine the optimal placement of the radio module. To perform the tests, all
you need is an electrical outlet for the radio module and a charged battery pack in
the handset.
2 Check to be sure the radio module’s power cord is unplugged from the wall outlet
before continuing.
Go to “Using Wireless Test Mode” in Chapter 3.