Filter
Top Products
Procedures Troubleshooting 5
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 119
SPARE LED on battery
charger flashes red.
Battery pack is defective.
Contacts on the battery pack or in the
battery charger’s spare battery
compartment are dirty.
Battery pack is not seated properly in
the spare battery compartment.
If you have a battery pack in the
handset and one in the spare battery
compartment, remove both battery
packs from the charger to clear the
red flashing LED. Then test each
battery pack separately as follows:
1 Insert the battery pack in the
handset and place the handset in
the battery charger’s handset
cradle.
2 Wait one minute. If the
HANDSET LED flashes red,
order a new battery pack.
1 Verify that there are no
obstructions on the battery pack
or battery charger contacts.
2 Unplug the charger and clean
the contacts with a soft eraser.
3 Clean the battery pack contacts
with a soft eraser.
Reseat the battery pack in the
battery charger’s spare battery
compartment, as described in
Chapter 3.
Handset is in the battery
charger cradle and the
HANDSET LED does
not light.
Handset is not seated properly in the
battery charger cradle.
Battery power supply is not plugged
in.
Reseat the handset in the battery
charger cradle.
Check that the charger power cord
is plugged into the charger and into
an electrical outlet that is not
controlled by a wall switch.
Symptoms Possible Causes Possible Solutions