Filter
Top Products
MDW 9031 Compatibility MDW 9031/9031DCP Pocket Phone Compatibility 6
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 125
Setting the Line
Ringing Options for
PARTNER Systems
Use the following guidelines to ensure optimal voice quality when using MDW 9031
Pocket Phones with a PARTNER, PARTNER Plus, PARTNER II, or PARTNER
Advanced Communications System in key mode:
Note: For PARTNER II hybrid systems that use pooled lines, set the Line
Ringing options as described in the following table if more than six
MDW 9031 Pocket Phone handsets have the same pooled line
appearance.
The MDW 9031 does not have a speaker; therefore, it does not support voice announce/page and call groups.
MERLIN Systems • On MERLIN II and MERLIN LEGEND Systems, you must connect your
wireless phone to an available jack on either a 408 outside line/analog telephone
module or an 008 analog telephone module.
• Since the MDW 9031 does not have a speaker function, the Voice Announce
feature must be disabled. It is recommended that you use MERLIN 206/410/820
Systems installed with Feature Package 2 with your wireless phone, so that you
can disable that feature.
• Since the MDW 9031 has no speaker function, it should not be assigned to a
paging group.
Telephone
Communications
System
TransTalk 9000 System with
Two Carriers (one control and
one expansion carrier)
TransTalk 9000 System with Three
Carriers (one control and two
expansion carriers)
PARTNER
1 Set Line Ringing for each
extension that has a radio
module in the control carrier to
Ring.
2 Set Line Ringing for each
extension that has a radio
module in the expansion carrier
to No Ring. (Install an external
audible alert for these
extensions.)
Not applicable; PARTNER supports up
to 12 phones.
PARTNER Plus
PARTNER II
PARTNER Advanced
Communications System
1 Set Line Ringing for each
extension that has a radio
module in the control carrier to
Ring.
2 Set Line Ringing for each
extension that has a radio
module in the expansion carrier
to Delayed Ring.
1 Set Line Ringing for each extension
that has a radio module in the control
carrier to Ring.
2 Set Line Ringing for each extension
that has a radio module in the
expansion carrier #1 to Delayed
Ring.
3 Set Line Ringing for each extension
that has a radio module in the
expansion carrier #2 to No Ring.
(Install an external audible alert for
these extensions.)