Filter
Top Products
3 Using the MDW 9031/9031DCP Pocket Phone Handset
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16674 Issue 3 October 1999
Line Status Indicators There are 12 status indicators; each one corresponds to a specific outside line or
programmable/intercom/drop button. (The function of these status indicators varies,
depending on the communications system you are using—see the Button Mapping
topic for the appropriate communications system switch in Chapter 6, “MDW
9031/9031DCP Pocket Phone Compatibility.”) The status indicators show either a
truncated triangle or a rectangle, signifying the following activity:
For PARTNER Systems:
A rectangle ( ) is the equivalent of a red LED on a wired system phone.
A truncated triangle ( ) is the equivalent of a green LED on a wired system phone.
For all other Systems:
A rectangle ( ) is the equivalent of a green LED on a wired system phone.
A truncated triangle ( ) is the equivalent of a red LED on a wired system phone.
Range Indicators For maximum range and voice quality, always fully extend the antenna before placing
or answering a call. The antenna must be either fully retracted (for short range)
or fully extended (for maximum range) to use the Pocket Phone.
The handset provides an audible and a visual signal to alert you when the handset is
near the end of the range of the radio module. Depending on how far away the
handset is from the radio module, the signals function as follows:
• The handset emits two beeps and flashes the RANGE indicator continuously.
Out of optimal range. You have walked into an area that is near the end of the
operating range of the radio module. You can continue your conversation or
initiate a call, but you are likely to experience a degradation in voice quality.
• The handset emits five sets of beeps and displays the RANGE indicator.
Loss of communication link. You have walked into an area that is out of the
operating range of the radio module. You must bring the handset within range of
the radio module within several seconds or the handset will turn off. If the handset
turns off, it appears that your call was disconnected; however, it was only placed
on Hold. To talk with your party, move back toward the radio module, press
O, then proceed as you would for any call placed on Hold.
• When you try to make a call, the handset emits two beeps and flashes the
RANGE indicator twice; then the handset automatically turns off.
Cannot establish communication link. You are completely out of range of the
radio module. To make the call, move back towards the radio module and try
again.
Refer to Chapter 5, “Troubleshooting,” for additional information about out-of-
range conditions.