Filter
Top Products
2 Installing the MDW 9031/9031DCP Pocket Phone Installing a Single Radio Module
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16620 Issue 3 October 1999
7 Plug the power cord/AC adapter into a properly grounded, 3-prong wall outlet
that is not controlled by an on/off switch.
!
CAUTION:
Never connect or disconnect the telephone line cord while the radio module is
plugged into the wall outlet.
Single Radio Module Installation Self-Test
Verify that the POWER and PASS LEDs on the radio module light. If the radio module’s PASS LED does not
light:
1 Unplug the power cord/AC adapter from the wall outlet.
2 Wait 15 seconds.
3 Plug it in again.
4 If the radio module’s PASS LED still does not light, refer to Chapter 5,
“Troubleshooting.”
PO
W
E
R
R
A
D
IO
PASS
Radio
Module
POWER
RADIO
PASS