Filter
Top Products
Installing a Single Carrier Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 31
Installing a Single Carrier on a Shelf or Desk
• You will not receive optimum performance if the unit is placed on a desk or low
shelf.
• Install the unit as high as possible, leaving 6 to 12 inches (15.2 to 30.5 cm)
between the top of the antenna and the ceiling, if on a high shelf.
• Never install or remove a radio module from a carrier that is plugged into a wall
outlet (hot insertion).
• See “Key Components” earlier in this chapter for additional picture detail.
To install a single carrier:
1 Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to
determine the optimal placement of the radio module. To perform the tests, all
you need is an electrical outlet for the radio module and a charged battery pack in
the handset.
2 Check to be sure the carrier’s power cord is unplugged from the wall outlet before
continuing.
3 Remove the plastic cap covering each radio module’s card edge before installing
the radio modules in the carrier.