Filter
Top Products
2 Installing the MDW 9031/9031DCP Pocket Phone Important Safety Instructions
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16610 Issue 3 October 1999
WARNING:
!
The rechargeable battery pack may contain elements that are harmful to
the environment (for example, nickel). Do not burn or puncture the
battery pack. As with other batteries of this type, burning or puncturing
could release toxic material which could cause injury. Do not dispose of
the battery pack in household garbage. For information about recycling
or proper disposal, consult your local solid waste (garbage) collection
or disposal organization.
Additional Safety Instructions for Installation Personnel
• Install the product to meet all environmental and electrical requirements listed in
Appendix C.
• All wiring that connects to this equipment and becomes part of the building
wiring must be a minimum of CLASS 2 or UL (Underwriters Laboratories)
Listed Communications cable.
• Do not install telephone wiring during a lightning storm.
• Do not install telephone jacks in a wet location unless the jack is specifically
designed for wet locations. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Install this product securely on a stable surface. Damage may result if the product
falls.
• Never place this product near or over a radiator or heat register.
• Slots and openings in the housing and the back or bottom are provided for
ventilation. To protect the housing from overheating, these openings must not be
blocked or covered. Therefore, do not place the product on a bed, sofa, rug, or
other similar surface. Also, do not place this product in an enclosed area unless
proper ventilation is provided.
• Install this product in a protected location where no one can step on or trip over
power cords and telephone line cords. Do not place objects on the cords that may
cause damage or abrasion.
• Do not allow anything to rest on the power cord. Do not locate this product where
the cord will be abused by persons walking on it. Do not overload wall outlets,
since this increases the risk of fire or electric shock. Do not staple or otherwise
attach the power cord to building surfaces.
• Use only the power supply (Comcode 847713583) shipped with this product for
the battery charger.
• Use only the power supply (Comcode 847523404) shipped with this product for
the radio module.
• Use only the power supply (Comcode 847224227) shipped with the carrier.
• Use only the correct power source. If you are not sure of the power supply to your
location, consult your local power company.