Filter
Top Products
5 Troubleshooting Procedures
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166118 Issue 3 October 1999
HANDSET LED
flashes red.
Battery pack is defective.
Contacts in the handset cradle or on
the battery pack are dirty.
Handset is not seated properly in
battery charger’s handset cradle.
If you have a battery pack in the
handset and one in the spare battery
compartment, remove both battery
packs from the charger to clear the
red flashing LED. Then test each
battery pack separately as follows:
1 Place the battery pack in the
battery charger’s spare battery
compartment.
2 Wait one minute. If the SPARE
LED flashes red, order a new
battery pack.
1 Verify that there are no
obstructions on the handset or
battery charger contacts.
2 Unplug the charger and clean
the contacts with a soft eraser.
3 Clean the handset contacts with
a soft eraser.
Reseat the handset in the battery
charger’s handset cradle, as
described in Chapter 3.
SPARE LED on battery
charger does not light
when battery pack is
placed in spare battery
compartment.
Battery pack is not seated properly in
the spare battery compartment.
Contacts on the battery pack or in the
spare battery compartment are dirty.
Battery pack is defective.
Reseat the battery pack in the
battery charger’s spare battery
compartment.
1 Verify that there are no
obstructions on the battery pack
or battery charger contacts.
2 Unplug the charger and clean
the contacts with a soft eraser.
3 Clean the battery pack contacts
with a soft eraser.
1 Insert the questionable battery
pack in the handset and place
the handset in the handset
cradle.
2 Wait one minute. If the
HANDSET LED flashes red,
order a new battery pack.
Symptoms Possible Causes Possible Solutions