Lucent Technologies MDW 9031 Cordless Telephone User Manual


 
3 Using the MDW 9031/9031DCP Pocket Phone Battery Charger
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-16692 Issue 3 October 1999
The color of the battery charger’s LEDs indicates the state of the corresponding battery pack, as shown in the
following table:
Extending Battery Life
The battery charger will charge a battery pack in the handset if you simply insert the handset in the battery
charger’s handset cradle; however, the Refresh process fully discharges the battery pack before recharging it,
thereby ensuring the best possible charge and the longest talk time.
“Memory effect” reduces a battery's capacity and can occur when you repeatedly recharge a battery pack before
it is fully discharged. The nickel metal hydride battery pack shipped with your MDW 9031/9031DCP is resistant
to the memory effect. Even so, it is recommended that you refresh your battery pack at least once a week.
The following table shows how long refreshing takes using a Model 40B charger, depending on how much
charge is left in the battery pack when you insert it into the charger and press the REFRESH button:
Battery charger
LED shows...
If it is the SPARE LED,
the battery pack in
the spare battery
compartment...
If it is the HANDSET
LED, the battery pack
in the Handset...
If it is the REFRESH LED,
the Refresh button was
pressed, and the Handset
battery pack...
Steady orange Is charging Is charging N/A
Steady green Is fully charged Is fully charged N/A
Flashing red
See Note below.
Has one of the following
problems:
Is not seated properly in
the charger
Has dirty contacts
Is defective
Has one of the following
problems:
Is not seated properly in
the charger
Has dirty contacts
Is defective
N/A
Steady red Is in the Discharge
portion of the Refresh
cycle
Is in the Discharge
portion of the Refresh
cycle
Is in the Discharge portion of
the Refresh cycle
Note: If either the SPARE LED or the HANDSET LED is flashing red, both battery packs must be
removed from the charger to clear the flashing-red condition. Address the possible problems
for one battery pack at a time to determine whether one is bad.
Note: The SPARE LED may turn amber instead of red when jostled in the spare battery charging
compartment. Remove the battery then place it back into the charger to clear the condition.
Battery Pack Battery-Pack Charge State
Discharge
Time
Recharge
Time Total Time
Standard Battery
Pack
Low charge (Battery icon is lit) 0.5 hours 1.25 hour 1.75 hours
Full charge 3 hours 1.25 hour 4.25 hours
Extended Battery
Pack
Low charge (Battery icon is lit) 0.5 hours 3.25 hours 3.75 hours
Full charge 8 hours 3.75 hours 11.75 hours