Filter
Top Products
Installing Multiple Carriers Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 43
4 Place the carrier assembly over the screws, then slide it downward to lock it into
place. Be sure that the leftmost carrier is the control carrier. Tighten the screws.
Repeat for each carrier.
5 Connect an expansion cable to the OUT jack of the control carrier.
6 Insert the free end of the expansion cable into the IN jack of the expansion carrier
immediately to the right of the control carrier.
Note: Although installing an expansion cable into the wrong IN or OUT jack
will not harm either carrier, doing so causes all handsets to work
improperly and the OUT OF SYNC LED to light.
7 If you have a second expansion carrier:
a Connect an expansion cable to the OUT jack of expansion carrier #1.
b Insert the free end of the expansion cable into the IN jack of expansion
carrier #2.
See “Key Components” earlier in this chapter for an illustration of a four-
carrier setup.
CAUTION
U
S
E
O
N
LY
AT&T
C
A
B
L
E
P
⁄
N
8
4
7
6
6
7
8
9
6
IN
OUT
OUT OF S
YNC
CONTROL/
EXPANSION
CAUTION
USE ONLY
AT&T CABLE
P⁄N 847667896
IN
O
U
T
From
Control
Carrier
OUT OF SYNC
CONTROL/
EXPANSION