Filter
Top Products
Important Safety Instructions Installing the MDW 9031/9031DCP Pocket Phone 2
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 9
• Read and understand all instructions in this book before using this product.
• Observe all warnings and instructions marked on the product.
• Do not use the product near water or when you are wet. If the product comes in
contact with any liquids, unplug the power cord and telephone line cords
immediately. Do not plug the product back in until it has dried thoroughly.
• Never push objects of any kind into this product through housing slots, since the
objects may touch hazardous voltage points or short out parts that could result in a
risk of electric shock. Never spill liquid of any kind on the phone.
• If you suspect a gas leak, report it immediately, but use a phone away from the
area in question. The phone’s electrical contacts could generate a tiny spark.
While unlikely, it is possible that this spark could ignite a heavy concentration of
gas. This product is not approved for use in areas labeled by the Occupational
Safety and Health Administration (OSHA) as “explosive environments.” Only
“Explosive Atmosphere Telephones” may be used in such hazardous
environments.
• Unplug this product from wall outlets and telephone jacks before cleaning. Clean
exposed parts with a soft, damp cloth. Do not use liquid or aerosol cleaners.
• Unplug this product from the wall outlet, remove the telephone line cord from the
modular wall jack or communications system switch/control unit, and refer
servicing to qualified service personnel under the following conditions:
~ When the power cord or plug is damaged or frayed.
~ If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
instructions, since improper adjustment of other controls may result in damage
and will often require extensive work by a qualified technician to restore the
product to normal operation.
~ If the product has been dropped and the housing has been damaged.
• This product should be serviced by a qualified service center when service or
repair work is required. Do not open the product; there are no user-serviceable
components inside.
• Always unplug the power cord/AC adapter for the carrier(s) from the wall outlet
when:
~ Removing a radio module.
~ Moving a radio module to a new slot in the carrier.
~ Installing a new radio module.
~ Connecting or disconnecting telephone line cords.
~ Adding a carrier.
• Use only the type of battery pack shipped with this product or sold as an optional
part. (See “Ordering Replacement and Optional Parts” in Chapter 4.)