Filter
Top Products
MDW 9031DCP Compatibility MDW 9031/9031DCP Pocket Phone Compatibility 6
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166 Issue 3 October 1999 137
The following illustrations show in parentheses the MDW 9031DCP Pocket Phone
button assignments on Pages 3 and 4 of the STATION Administration screens. The
button labeled D on the MDW 9031DCP Pocket Phone display automatically defaults
to the button labeled 04 (Drop) on the 8410D phones.
Note: Page 3 above is the recommended button programming. The Feat/P button must be pressed
twice to Exit from the Softkey menu (for example, exiting Directory mode). Button 8 on the
MDW 9031DCP phone, when used with Line Preselection, allows for toggling between the
two lines of display information.
add station next Page 3 of 4 SPE B
STATION
SITE DATA
Room: Headset? n
Jack: Speaker? n
Cable: Mounting: d
Floor: Cord Length: 0
Building: Set Color:
ABBREVIATED DIALING
List1: List2: List3:
BUTTON ASSIGNMENTS
1: (A) call-appr 6: (3)
2: (B) call-appr 7: (4)
3: (C) call-appr 8: (5)(Dir)
4: (1) 9: (6)(Next)
5: (2) 10: (7)(Call Display)
add station next Page 4 of 4 SPE B
STATION
SOFTKEY BUTTON ASSIGNMENTS
1
2:
3:
4:
5:
7:
6:
8:
9:
10:
11:
12:
Note: All Softkey button assignments should be initially removed
when administering an MDW 9031DCP terminal. The desired Softkey
features can then be properly programmed on the DCP Pocket Phone
Programmable buttons (buttons 1-7). Button 8 is a firmware-
programmed hard Scroll button on the MDW 9031DCP phone.