CHAPTER 7. INSTALLING INTEL DIALOGIC BOARD DRIVERS 7-27
5. In the Value field, enter
Spandti.prm
.
6. Click
OK.
7. Repeat for each additional Robbed Bit T1 trunk board
8. In Windows Explorer, navigate to
Program Files\Dialogic\Data\Spandti.prm. Open
the file in Notepad.
9. Edit the file by adding the following lines:
0014 01; ESF framing
0020 01; B8ZS
10. Save and close the file.
If you have Internet telephony boards, go to the next section. Otherwise, perform any other
required board-specific configuration steps described in the table on page 7-19. When you are
done, go to “Test-starting the Intel Dialogic drivers” on page 7-33.