Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
CHAPTER 6. INSTALLING INTEL DIALOGIC BOARDS 6-7
If you have both ISA and PCI boards: Use the SCbus-to-CTbus adapter to connect
all the boards together so that they can use the same telephony bus. Only one
SCbus-to-CTbus is required per PC. See Troubleshooting mixed CTbus board
systems on page C-8 for more information about mixed-board configurations.
Place the adapter on the 68-pin CTbus edge connector on the PCI board that is
adjacent to the first ISA board. The adapter hangs off the end of the board.
Connect the SCbus ribbon cable to the SCbus side of the adapter.
Connect the CTbus ribbon cable to the CTbus side of the adapter.
When properly connected, the two ribbon cables will lie flat, and the colored stripe
on one edge of both ribbon cables will face toward the bracket end of the boards.
5. After installing and connecting all of your boards, replace the PC cover and power
cords.
Go to the next section.
Connecting trunk boards to trunk lines ______________________
Connect the Intel Dialogic trunk boards to trunk lines according to the type of phone service you
use. This section describes how to connect the following:
Regular analog trunk boards. See page 6-8.
Analog DID trunk boards. See page 6-8.
Robbed Bit T1 trunk boards. See page 6-9.
ISDN PRI T1 trunk boards. See page 6-9.
ISDN PRI E1 trunk boards. See page 6-9.
ISDN E1 CAS trunk boards. See page 6-10.
ISDN BRI trunk boards. See page 6-10.