CHAPTER 7. INSTALLING INTEL DIALOGIC BOARD DRIVERS 7-17
4. The BLTAddress parameter contains the base memory address assigned to Intel
Dialogic. Verify that this base memory address is not being used by another board or
program.
Note:
If there are other SCSI devices attached to the PC, they probably use the same
base memory address (the default is d8000). It is easier to change the base memory
address for the other devices than to change the address assigned to Intel Dialogic in
DCM.
Go to the next section.
Setting digital trunk boards to use the clocking signal sent by the
telephone company
Select an Intel Dialogic telephony board with a digital line connected to the telephone company
to provide the clocking signal to the other trunk boards connected via the bus ribbon cable in the
TeleVantage Server.
1. To set your trunk boards to use the clocking signal sent from the telephone company,
in the main DCM dialog box, under
TDM Bus, double-click Bus-0.
2. Select the parameter
Primary Master FRU (User Defined) and then select a digital or
analog trunk board from the
Value drop-down list.