CHAPTER 7. INSTALLING INTEL DIALOGIC BOARD DRIVERS 7-29
Configuring digital station boards
Perform the steps in this section only if you have one or more DSIx boards installed.
You must specify the following for each DSIx board:
Digital phone family that you will support via the board, for example ‘Nortel Norstar
7xxx’.
Important:
You must configure the same digital phone family for each DSIx board
installed in the TeleVantage Server. TeleVantage does not support a mix of digital phones
from different families or manufacturers on the same Server.
Specific digital phone model in that family that you will connect to each port on the
board, for example ‘Nortel Norstar M7324’. Each port must be configured for the correct
phone type. If you unplug a phone from a port, you can only replace it with the same
model, unless you reconfigure the port and specify a different model.
Note:
You use the Intel MEA Configuration program to configure DSIx boards as described
below, not the Intel Dialogic Configuration Manager.
To configure a DSIx board
1. From the Start menu, choose
Programs >Intel(R) Media Exchange Architecture
Boards > Configuration Manager
. The Intel MEA Configuration main dialog box
opens, displaying the DSIx boards installed on the TeleVantage Server.