Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
7-10 INSTALLING INTEL TELEPHONY COMPONENTS
3. In the Setup Complete dialog box, select Yes, I want to restart my computer now,
and then click Finish. Do not remove the Intel Dialogic CD yet.
4. After your PC restarts, log on as the same user you logged on as previously. The
installation continues.
Note:
If the Windows Found New Hardware wizard starts, click Cancel to close it. To
prevent the Found New Hardware wizard from starting whenever the TeleVantage
Server starts (Windows 2000 TeleVantage Servers only), see PCI boards not
recognized at Server startup on page C-8 after the installation completes.
5. When the Setup Complete dialog box opens again, indicating that installation is
complete, click Finish.
You can now remove the Intel Dialogic CD from the CD drive, unless you are
optionally installing the DSI drivers or GlobalCall 4.3 as described in the following
sections.
6.
If you are upgrading from a previous version of TeleVantage and you had manually
edited any Intel Dialogic .prm, .pcd, or .config files, edit the corresponding new files
and make the necessary changes. For reference, you can use the copies of your files
that were backed up by the TeleVantage Intel Driver Clean-up Utility (as described in
step 5 on page 7-5.)
Installing the Intel Dialogic DSI board drivers __________________
Perform the following steps only if you are using one or more Intel Dialogic DSIx telephony
boards in order to support digital phones. (DSIx boards are not used to support Toshiba digital
phones or VoIP phones.)
To install the Intel Dialogic DSI board drivers
1. In the Driver Setup, click
Intel Dialogic DSI Board Drivers.