Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
7-32 INSTALLING INTEL TELEPHONY COMPONENTS
6. Repeat step 5 for the rest of the ports that you plan to use on the board.
7. Click
OK to save your changes.
8. Repeat steps 2-7 for any additional DSIx boards installed in the TeleVantage Server.
If you have DI0408LSAR2 integrated analog trunks and station boards, go to the next section.
Otherwise, perform any other required board-specific configuration steps described in the table
on page 7-19. When you are done, go to Test-starting the Intel Dialogic drivers on page 7-33.
Configuring DI0408LSAR2 integrated analog trunk and station boards
This section is optional, and only applies if both of the following are true:
Your TeleVantage Server contains two or more network interface connections (NICs).
You want to specify which NIC is used for RTP/RTCP audio traffic. The other NIC(s)
will be used for your other network traffic.
Note:
Once this global setting is set according to the following instructions, it will be used by all
DI0408LSAR2 boards on the TeleVantage Server.
Perform the following steps:
1. Start the Intel Dialogic Configuration Manager (DCM) if it is not already running. See
See Appendix D, Using the Intel Dialogic Configuration Manager for instructions.
2. In the DCM main dialog box, double-click the first DI0408LSAR2 board.
3. Click the Misc tab.