Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
CHAPTER 6. INSTALLING INTEL DIALOGIC BOARDS 6-5
To assign board IDs
1. Locate the switch or switches on the side of each board.
2. Set the board ID:
Intel Dialogic trunk boards, Internet telephony boards, voice resource boards,
and conference bridge boards.
Set the board ID by dialing the single SW100
rotary switch to one of the 16 available settings (0-F).
MSI/x station boards. Set the board ID to one of the 32 available settings (0-31)
using the two switches on the board:
To set board IDs 0-15, set the SW2 switch to OFF and dial the SW1 rotary
switch to one of the sixteen settings from 0-F.
To set board IDs 16-31, set SW2 to ON and dial the SW1 rotary switch to one
of the sixteen settings from 0-F.
The ON and OFF positions of the SW2 switch are indicated by silk-screened letters on
the board.
When you have set your board IDs, go to the next section.