Filter
Top Products
APPENDIX B. CONFIGURING INTEL DIALOGIC BOARD ISDN PARAMETERS B-9
------00 Screening Indicator
6176661818 Number Digit(s)
>>>> End of outbound ID
1: CALLED PARTY NUM(0x70)
2: IE Length(0x0c)
3: 1------- Extension Bit
-000---- Type of Number
----0000 Numbering plan ID
16175554444 Number Digit(s)
Using the ISDN Two B-Channel Transfer test utility
The ISDN Two B-Channel Transfer test utility can be used to make sure your ISDN line is
correctly configured by your phone company to support ISDN Two B-Channel Transfer service,
which allows calls to be transferred or forwarded to external numbers without consuming
TeleVantage trunks. For more information, see Administering TeleVantage, Chapter 5, “Using
Two B-Channel Transfer.”
The ISDN Two B-Channel Transfer test utility (
ISDN2BCT.exe) is included on Master CD in
the
\support\ISDN2BCT folder. You can run the utility from there, or copy it to another location.
If the feature does not appear to be working, verify the following:
You ordered the Two B-Channel Transfer feature from the phone company for the ISDN
line using the NI2 protocol.
Using the TeleVantage Administrator, edit the ISDN PRI T1 span and click the Tuning
tab. Make sure that the
Supports Two B Channel Transfer checkbox is selected. If not,
select the checkbox, restart the span, and test the feature again.
If the service still does not work, run the ISDN Two B-Channel Transfer test utility.
To run the ISDN Two B-Channel Transfer test utility
1. Shut down the TeleVantage Server if it is running.
2. On the TeleVantage Server, open a command prompt window, and then change to the
directory where
IDSN2BCT.exe was copied.
3. Run the following command:
ISDN2BCT -n<outboundNum> [-b<brdNum>]
where:
<outboundNum>
(Required) The outbound number to call to initiate a Two B-Channel
Transfer request.
<brdNum>
(Optional) The Intel Dialogic board number to use for the test. The default
is 1