Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
APPENDIX D
APPENDIX D
USING THE INTEL DIALOGIC
C
ONFIGURATION MANAGER
The Intel Dialogic Configuration Manager (DCM) is used to perform many of the configuration
tasks in Chapter 7, Installing Intel Dialogic Board Drivers.
This appendix describes how to perform the following basic functions using DCM:
Start and exit DCM.
Start the Intel Dialogic drivers.
Stop the Intel Dialogic drivers. Important: In order to make changes to how boards are
configured, the Intel Dialogic drivers must be stopped.
Configure DCM in order to run it remotely using Windows Terminal Services. See page
D-2 for instructions. See Appendix A in Installing TeleVantage for more information
about using Terminal Services with TeleVantage.
Note:
Toshiba Strata CS-DKTU station boards do not appear in DCM. They appear in Windows
Device Manager under System Devices and are identified as
CTS:PCDKSC card
.
To use the Intel Dialogic Configuration Manager
1. Click
Start > Programs > Intel Dialogic System Software > Configuration Manager
- DCM
.
2. In the Computer Name dialog box, select the TeleVantage Server PC, and then click
Connect. Wait while DCM detects the boards installed on the Server.
3. After board detection is complete, the status of the Intel Dialogic drivers (Stopped,
Running, and so forth) is displayed at the bottom of the DCM main dialog box.
To start the Intel Dialogic drivers if they are stopped, click the green button on the
toolbar, or choose
Service > Start Service.
To stop the Intel Dialogic drivers if they are running, click the red button on the
toolbar, or choose
Service > Stop Service.
4. To exit DCM, choose
File > Exit.