Vertical Communications TeleVantage 7.5 IP Phone User Manual


 
E-4 INSTALLING INTEL TELEPHONY COMPONENTS
Notes
Each of the following notes applies to specific telephony boards as referenced in the Notes
column in the Basic Board Information table. As indicated below, in some cases the Note applies
only when the board is configured with the media load(s) listed.
1. A TeleVantage trunk license is required for each trunk connected to the board. For the
following boards, applies to certain media loads:
DM/IP241-1T1-P100: All media loads except iptk_t1_311
DM/IP301-1E1-P100: All media loads except iptk_e1_311
DM/IP481-2T1-P100: All media loads except ipt_2isdn_5ess_311
DM/IP601-2E1-P100: All media loads except ipt_2isdn_net5_311
DI0408LSAR2: All media loads except DI0408LSA_REV2_ML5
2. A TeleVantage station license is required for each station connected to the board. For
the DI0408LSAR2 board, applies to all media loads except DI0408LSA_REV2_ML5.
3. With the following boards/media loads, voice resources on the board are not available
for use by TeleVantage:
DM/IP241-1T1-P100: iptk_t1_311
DM/IP301-1E1-P100: iptk_e1_311
DM/IP481-2T1-P100: ipt_2isdn_5ess_311
DM/IP601-2E1-P100: ipt_2isdn_net5_311
DI0408LSAR2: DI0408LSA_REV2_ML5
4. A TeleVantage IP Port license is required for each VoIP port on the board. For the
DI0408LSAR2 board, applies to all media loads except DI0408LSA_REV2_ML4.
5. Can only be used with an embedded H.323 VoIP stack.
6. Fax and/or CSP resources on the board are not available for use by TeleVantage, but
can be used by 3rd-party applications. For the DI0408LSAR2 board, applies to all
media loads except DI0408LSA_REV2_ML5.
7. Includes an external station interface box (SIB) which provides analog service for
station activity.
8. Can be used in any European country that supports the CTR21 telephony standard.
9. When used with the CAS protocol, each E1 line on the board requires one voice
resource at all times. The remaining voice resources are available for stations and other
uses. For the DM/V1200A-4E1-PCI board, applies to all media loads except
ml1b_qsa_net5 and ml1b_qsa_qsige1.
10. Produces a ringing voltage of approximately 50 volts/2 REN. Verify that your phones
meet this specification.