Filter
Top Products
CHAPTER 3. OPERATING THE CONSOLE
9. If the called party is busy or does not answer, press (Cancel).
• Outgoing call is canceled.
• Call progress tone stops.
.
• Console is connected to the caller again.
• Split lamp goes dark.
Explain to the caller that the called party cannot be reached. Take a message, or
ask the caller to try again later; then press (Release).
• Procedure complete.
10. To set up a 3-way connection, press (Split) before or after the called party answers.
• Console, caller, and called party are connected together.
• Split lamp goes dark.
• Procedure complete.
To extend an incominq trunk call to an outside number:
1.
After answering the incoming call, tell the caller that you are going to break the
connection temporarily (split) while you call the other party.
2. Call the desired party using the normal procedures for placing an outgoing trunk call.
• Split lamp lights.
• If a trunk is not available, reorder tone is heard; press (Split) to reconnect to
the caller. Ask the caller to try again later.
3. Use one of the following steps, 4 through 7, to complete the call.
4. If you are not going to announce the call, press (Release) as soon as the call starts
ringing.
• Calling party is connected to the ringing line.
• Split lamp goes dark.
• Procedure complete.
3-12