Filter
Top Products
Vmux-2100 Installation and Operation Manual Chapter 7 Monitoring and Statistics Collection
Collecting Statistics 7-7
Table 7-2. Sanity Errors and Warnings (Cont.)
Display Type Description
ILLEGAL DESTINATION IP
ADDRESS
Error Destination IP address for a bundle is not defined
ILLEGAL SOURCE IP ADRESS Error A group IP address is illegal or not defined
Note: The following IP addresses are reserved for the main and voice card internal communication and cannot
be assigned by the user: 1.1.1.255 and 1.1.1.0 to 1.1.1.8.
TS INCLOMPATIBLE WITH E1
TYPE
Error Timeslot 16 is configured to HDLC when E1 is set to the
G.732S framing mode. Timeslot 16 configuration must be
changed to not connected
TOO MANY CONFIGURED
TS
Error Number of timeslots assigned to carry voice exceeds the
number of timeslots supported by the unit
TS 16 SHOULD BE
DISCONNECTED IN CAS
MODE
Error Timeslot 16 is configured to Voice when operating Vmux-2100
with CAS signaling. Timeslot 16 configuration must be changed
to not connected
7.3 Collecting Statistics
This section explains how to display performance data collected on the
Vmux-2100 main link and E1/T1 groups.
Displaying Statistics on the Main Link Ports
Vmux-2100 evaluates performance of the 10/100BaseT port and calculates the
main card CPU utilization.
Collecting the Main Link Ethernet Statistics
To display the main link Ethernet statistics:
1. From the Main menu, choose Monitoring.
The Monitoring menu appears.
2. From the Monitoring menu, choose Statistics.
The Statistics menu appears (see Figure 7-6).
Statistics
1. Cards statistics
2. Main Module statistics
@ - Db Update; # - Db Undo
ESC-prev.menu; !-main menu; &-exit
Figure 7-6. Statistics Menu
3. From the Statistics menu, choose Main Module statistics.
The Main Module Statistics menu appears (see Figure 7-7).