Chapter 4 Management from a Terminal Vmux-2100 Installation and Operation Manual
4-6 Configuring the Vmux-2100 System
Configuration
1. System
2. Hub
3. Card
@ - Db Update; # - Db Undo
ESC-prev.menu; !-main menu; &-exit
Figure 4-4. Configuration Menu
2. From the Configuration menu, choose System.
The System menu appears (see Figure 4-5).
System
1. Management
2. Control Port
3. Date & Time Update
4. Factory Default
5. Show Partition information
6. Set the Active Application
7. Reset Card
8. Open Internal Alarms
@ - Db Update; # - Db Undo
ESC-prev.menu; !-main menu; &-exit
Figure 4-5. System Menu
Configuring Ethernet Management Connection
Vmux-2100 can be managed by a network management station, which is located
on the LAN connected to the unit’s 10/100BaseT port. In order to establish a
proper connection, it is necessary to configure the following:
• Host IP address, subnets mask, default gateway, its trap, read and write
communities.
• Manager IP addresses.
Configuring the Host IP
The management host parameters are configured via the Host IP menu.
To configure the IP host parameters:
1. From the System menu, choose Management.
The Management menu appears (see Figure 4-6).