Filter
Top Products
Vmux-2100 Installation and Operation Manual Chapter 4 Management from a Terminal
Configuring Main Link and Voice E1/T1 Ports 4-19
Configure the timeslots of each E1/T1 port (voice or data, mapping to
specific bundles, routing to remote ports and timeslots).
Configuring the Main Link
The main link module of Vmux-2100 may include 10/100BaseT port and E1/T1
port.
Configuring the Ethernet Port
The Ethernet port of the Vmux-2100 main link module supports autonegotiation. If
the autonegotiation is disabled, the Ethernet port can be configured to operate in
10BaseT (half duplex or full duplex) or 100BaseT (half duplex or full duplex)
mode.
To configure the Ethernet port:
1. From the Configuration menu (see Figure 4-4), choose Card.
The Card menu appears (see Figure 4-21).
Card
1. Main board
2. Slot 1
3. Slot 2
@ - Db Update; # - Db Undo
ESC-prev.menu; !-main menu; &-exit
Figure 4-21. Card Menu
2. From the Card menu, choose Main board.
The Main Board menu appears (see Figure 4-22).
Main Board
1. Lan Parameters
2. E1 Parameters
@ - Db Update; # - Db Undo
ESC-prev.menu; !-main menu; &-exit
Figure 4-22. Main Board Menu
3. From the Main Board menu, choose Lan Parameters.
The Lan Parameters menu appears (see Figure 4-23).