Filter
Top Products
Answering calls / 53
P0603544 02 Compact ICS 6.1 System Coordinator Guide
3. Press
≠
.
Show set:
displays.
4. Enter the DN number of the T7316E which is attached to the eKIM
you want to program, then press
OK
.
5. Press
≠
.
Capabilities
displays.
6. Press
‘
two times until
User preferences
displays.
7. Press
≠
.
Model
displays (7316E+<n>KIM).
8. Press
‘
.
Button progrming
displays.
9. Press the
KIM
softkey for the KIM for which you want to program
buttons.
If no KIM softkeys appear, it means the KIM was not configured as a
CAP in programming.
10. Press
‘
until you find the button you want to program.
11. Press
TEL#
to enter an autodial number or Hunt group DN or press
FEATR
to enter a feature code and feature programming.
To make the
button blank, press
CLR
.
Monitoring telephones from the CAP
The indicator icons beside the buttons on the CAP show the status of
system telephones or lines that are configured on the CAP. Refer to ‘‘What
line indicators mean’’ on page 44 icons.
Release button
Pressing ends a call. You do not have to put the handset down.
also ends feature programming.
While you are on a call, do not press
to end a feature you are using. If
you do, you disconnect the call. Use
instead.
Hearing aid compatibility
The handsets on all Norstar and BST telephones are compatible with
hearing aids as defined in the FCC rules, Part 68, section 68.316. Not all
hearing aids are optimized for use with a telephone.