Nortel Networks 6.1 Telephone User Manual


 
98 / Auto Attendant
Compact ICS 6.1 System Coordinator Guide P0603544 02
For the M7100 or T7100 telephone, an external autodialer can be
programmed only by using a line and not a line pool.
Using intercom as the line for Autodial
If you press the button with the
label as the line for an external
autodial number, you must include a valid line pool access code or a
destination code. If line pool access codes or destination codes are
changed, remember to reprogram autodial numbers.
Displays
Tip -
If you do not include a line selection in an autodial
number, the call uses your prime line (if you have one).
Continue to enter digits until the number is
complete. Press
or
BKSP
to erase an
incorrect digit. Press
or
OK
when you are
finished.
The memory allotted to autodial numbers in your
Norstar system is full.
While programming external Autodial, you
erased the button by pressing
or
OK
before
entering any digits.
Enter the number you want to program (choosing
the line first if necessary) exactly as you would if
you were making a call.
Enter the internal telephone number you want to
program.
You are programming an internal autodial button
and have entered a number that is not an internal
number on your system. Enter a valid internal
number. If the number you are entering is a
destination code, use external autodial.
Press the memory button you want to program.
987__
QUIT BKSP OK
Autodial full
Button erased
Enter digits
QUIT OK
Intercom
#
: ___
QUIT
Invalid number
Press a button
QUIT